Vista Online by Friends Of Vista, Inc. - A Texas Nonprofit Corporation | Informative Articles For Your Life | Click Here To Return To Index Page Of Site

How To Make Camping Shoot-the-Chute

   By: Daivd Z

Shoot-the-Chute

A "Shoot-the-Chute" is great fun and one should be built in every camp visit and "Swimming Hole." The one described below has stood the test of several years in many different camp sites.

The plan drawn is for a chute 40 feet long, 3 feet wide and 18 feet high. These dimensions can be changed in length and height, but not in width.

The chute is built of 7/8-inch matched pine boards, to the same width as sheet zinc, usually 3 feet; the boards being firmly cleated together on the under side by 2 x 6-inch cleats 5 feet apart, throughout the length of the chute.

Boards should be screwed to the cleats from the face of the chute with 1-1/2-inch screws, the heads being counter sunk.

The several lengths of zinc are soldered into one piece, the joints being on the under side (as shingles on a roof) fastened to the boards with 8-oz. tacks; set in from the edge about 1 inch and about 6 inches apart.

The side strips of maple (soft wood will not do on account of the danger of splintering) 2 inches wide and 3 inches high, rounded slightly on upper edge, are placed directly over the edge of the zinc and covering the tacks.

Screw the strips firmly to the chute with 2-inch screws from the under side. These ought to be placed not more than 2 feet apart. Probably each will have two or more strips in making a piece of sufficient length. If so, care should be taken to have the pieces joined on a bevel with a slant from outer edge toward bottom of chute, so as to leave no edge.

The utmost care should be used to have a perfectly smooth surface on the inside of the chute. A pump or bucket is needed at the top of the chute to wet the surface before the swimmer starts his slide.

The supports should be firmly braced with 2 x 4-inch timber, and lower end of chute should extend over the pier at least 1 foot and not nearer the surface of the water than 3 feet perpendicularly, allowing the swimmer to enter the water as in a dive.

The chute can be fastened to the supporting braces through timbers, into maple side strips with a good heavy log screw. A platform 3 feet wide and 4 feet long near the top of chute, and set just waist deep from the top of chute will make starting easy.

About the Author

Welcome to allcampings.com ( http://www.allcampings.com ), the Best Outdoor Action Guide about camping. Information on trip planning, clothing, travel, other camping skills, and much more...


Article Source: http://www.friendsofvista.org/articles/article6348.html





Related Articles

Write A Poem In Ten Minutes - Steve Gillman
Do You Know What A Didgeridoo Is? Do You Want To Do Or Learn - Jesse S. Somer
-
Jewelry Making For Fun And Profit - Sam Serio
-
-
-
-
Several Ways To Customize Your Leased Vehicle's Entertainment System - Dwayne Wright
Interview With Laura Hickey- Author Of Mysterious Chills And - LH Publications and Productions
   

 
Website Design and Logo Design by InfoServe Media, LLC

Copyright © 2014 Friends of Vista, Inc. TM - A Texas Nonprofit Corporation
Privacy Statement | Contact Us